 |
Français
|
|
Products >> Manure Systems >> Vertical Pumps
Vertical Pumps
 |
6”
Electric Manure Transfer Pumps
[Click to download
PDF version]
The 6” electric
manure transfer pump is designed to agitate and pump milking
parlor wastewater and hog manure with fast results. The
lower agitation nozzle will quickly agitate a small to
medium sized reception pit and will transfer manure through
a 4” PVC pipe up to several hundred feet (depending
on elevation).
The 6”
diameter impeller can agitate liquid at a rate of up to
480 GPM with a 5 HP electric motor. An oil-filled lower
bearing assembly, with greasable seals, insures a long
operating life. The 6” manure transfer pump is available
in 4’ through 14’ lengths.
|
|
 |
12
- 16” Electric Manure Transfer Pumps
[Click to download
PDF version]
The 12”
and 16” electric manure transfer pumps are designed
to agitate and pump out manure reception pits with minimum
hassle and maximum performance. Available in lengths from
6’ to 12’, and equipped with a 12” or
16” diameter impeller, our manure pumps can be equipped
with a wide variety of electric motors (7.5-40 HP) to
get the job done fast and easy.
Standard equipment
includes twin agitation nozzles that rotate 270 degrees,
a reliable triple sealed oil-bath lower bearing, and a
sliding stationary mounting bracket that allows for fast,
easy installation and servicing.
|
|
 |
20”
PTO Pumps
[Click to download
PDF version]
The high capacity
vertical PTO pump is built to tackle the toughest liquid
manure vertical wall pits around. Whether you need to
agitate a large dairy reception pit or an in-ground hog
manure storage pit, these pumps are built for the job.
They’re tough, rugged and reliable, and they can
be tailored for your operation. Choose from these models:
• 2-point
hitch mounted PTO powered pump with all-hydraulic controls
(including agitation nozzle, pump tilt & the agitate/fill
valve). Available in lengths from 6’ to 12’.
Powered by 540 or 1000 RPM PTO, the twin discharge nozzles
agitate manure pits fast.
• 2-point hitch mounted PTO powered pump with manual
controls for the agitation nozzle. The single discharge
nozzle agitates and ransfers manure from reception pits.
Available in lengths from 6’ to 12’.
All pumps feature
a heavy-duty 20” diameter impeller, a tubular-type
drive shaft that need no intermediate support bearings,
and an oil-bath lower bearing assembly with triple, greasable
seals to maintain reliable pump operation.
|
|
 |
20”
Electric Transfer Pumps [Click
to download PDF version]
20” electric
manure transfer pump is designed to agitate large manure
reception pits and transfer up to 500’ to long-term
storage. Available in lengths from 8’ to 12’,
these pumps can be equipped with a 50, 75 or 100 HP electric
motor to provide maximum pumping efficiency and performance.
All pumps feature
a heavy-duty 20” diameter impeller, a tubular-type
drive shaft that need no intermediate support bearings,
and an oil-bath lower bearing assembly with triple, greasable
seals to maintain reliable pump operation.
|
|
 |
Electric Prop Agitator [Click
to download PDF version]
The Jamesway
Electric Prop Agitator is used in reception pits to chop
and blend bedding and manure into an easy-to-pump liquid.
The back edge of the propeller is machined to scissor
material against the hardened stationary knife edges and
so reduces bedding length. The propeller may be aimed
in any direction during operation for thorough agitation.
The high speed
20 inch diameter propeller produces a strong, concentrated
stream of manure. The Jamesway Electric Prop Agitator
may be equipped with a 7.5, 10 or 15HP motor according
to the size of the reception pit. With larger motors,
the higher speed on the propeller produces a higher volume
stream that reaches further.
The propeller
is mounted on an oversized gearbox, assuring long life.
The gearbox is continuously charged with oil from the
reservoir, and the output seals are greased by remote
lines. The heavy square-tube body and high quality drive
system with fiberglass shield have been used for many
years in the 12” & 16” vertical pumps.
These pumps are famous for durability, often with motors
up to 40HP, so why would you want anything less? The Jamesway
Electric Prop Agitator is first class from top to bottom.
[Back
to the Top] |
|
|
 |
|